MAGNETO MAGNETIZER PDF

These may be welded or bolted to the hand truck frame. Great magnrto engine restorers, science experimenters, or even as a science fair project. We did it because of the challange. Gas Engine Magazine is your best source for tractor and stationary gas engine information. The metal core however is of very heavy steel and some machining operations may be required. The coils are connected in parallel and protected with diode arc suppressors.

Author:Yoshicage Kagalkis
Country:Hungary
Language:English (Spanish)
Genre:Photos
Published (Last):19 March 2006
Pages:17
PDF File Size:3.86 Mb
ePub File Size:4.15 Mb
ISBN:633-5-14202-871-1
Downloads:29785
Price:Free* [*Free Regsitration Required]
Uploader:Yozshubar



Diagram of connections of magnet recharger. Provided by H. Ritter The following includes tips on how to build and use a homemade magneto magnet charger. The cores of the electromagnet are made of soft bar steel one inch in diameter and three inches long.

All contacting surfaces should be absolutely flat and square so that there will be good metalic contact over the entire surfaces. Before the wire is wound on them, the magnet cores must be insulated. A spool may be formed by placing fiber or cardboard washers around each end of the magnet cores and then wrapping the magnet cores themselves with several layers of electricians tape. The winding for this recharger is for use on 6 or 12 volt direct current, from automobile storage batteries.

Applying three layers of No. However, No. Wind the wire around the electromagnet cores as shown in the illustrations and then wrap tape around the windings, to hold them in place. Mount the recharger on a wooden base large enough to also hold a single pole switch and a binding post.

Therefore, do not connect or disconnect the lead wires from the battery when the recharger is turned on. The windings will heat up quickly when in use; therefore, the switch should be closed for only a few minutes at a time.

When a magneto is taken apart for any reason, it must be assembled with the magnets in the same relative position as formerly, otherwise their polarity may be reversed and the magneto will be inoperative. The magnets must never be left off the magneto even temporarily, without placing a steel bar across their poles to serve as a keeper.

Unless this is done, they will lose their magnetism rapidly. Re-magnetizing the magnets of a magneto that has become weakened through long use is a simple process. It is important that unlike poles of the magneto magnets and of the electro magnets be brought together; i. To insure this, the current should be turned into the electromagnet and magneto magnet suspended over it on a string.

Starting at a distance of about 12 inches, slowly lower the magneto magnet. As you begin to lower the magneto magnet towards the electromagnet, the magneto magnet will automatically seek the proper polarity by swinging around and will then be strongly attracted to the electromagnet.

Then lay it on its side with its poles away from you and extending just beyond the far edges of the electromagnet poles. Apply a keeper to the magnet poles, switch off the current and withdraw the magnet sideways from the recharger.

The keeper should remain in place until the magnet is reassembled on the magneto. Share your thoughts. Jenny Related Content.

DER DREIZEHNTE STAMM PDF

How to Build and Use a Magneto Magnet Charger

Diagram of connections of magnet recharger. Provided by H. Ritter The following includes tips on how to build and use a homemade magneto magnet charger. The cores of the electromagnet are made of soft bar steel one inch in diameter and three inches long.

EKSERJI ANALIZI PDF

Magnetisers

Where could the average man pick up some of this? Also, a good heavy 40 amp knife switch? I like this style charger because, as he states, it will saturate any magnet without removing it form the rest of the assembly. Any help or ideas will be very much appreciated. Thanks and you all have a Happy New Year! I got the wire from a place that rebuilt industrial electric motors.

Related Articles